Connecting The Remote Gateway 9115 Unit To The Network - Nortel Remote Gateway 9110 Installation And Administration Manual

Installing the Remote Gateway 911x series unit

Connecting the Remote Gateway 9115 unit to the network

To connect the Remote Gateway 9115 unit to the network:
.
1 If you want to route calls over the IP network, or administer the Remote
Gateway 9115 unit using the IP network, add the unit to your Ethernet
network by making the following connections:
a. Connect one end of the Ethernet cable to the ETHERNET connector on
b. Connect the other end to either an Ethernet hub or a network router.
2 Connect the Remote Gateway 9115 unit to the power source as follows:
a. Connect the appropriate plug on the power transformer to the power
b. Plug the power connector into an uninterruptible power supply (UPS) or
3 Connect the Remote Gateway 9115 unit to the digital telephone as follows:
a. Connect one plug of the telephone cable supplied with the Remote
b. Plug the other end of this cable to the jack on the digital telephone.
4 Connect the Remote Gateway 9115 unit to the telephone line as follows:
a. Connect one end of the telephone cable that you supplied to the jack
b. Connect the other end of this cable to a telephone wall jack leading to
68
WARNING
Risk of equipment damage
To prevent damage to the Remote Gateway 9115 unit, ensure
that the power source to the unit is turned off until you
complete all connections.
the Remote Gateway 9115
connector on the Remote Gateway 9115 unit.
wall outlet.
Gateway 9115 unit to the jack marked DIGITAL PHONE on the rear
panel of the Remote Gateway 9115 unit.
marked ANALOG LINE on the rear panel of the Remote Gateway 9115
unit.
the PSTN (if using an analog connection only), or the data modem if it
provides analog line functionality and if using an IP network and analog
connection.
Remote Gateway 911x Series Installation and Administration Guide
unit
.
Standard 3.0