Auxiliary Files; Call Progress Tone And User-Defined Tone Auxiliary Files - Nortel Media Gateway 3500 Installation, Operation And Maintenance Manual

3. Unlock the Media Gateway.
12.7

Auxiliary Files

The auxiliary files are dat files each containing the raw data used for a certain task
such as Call Progress Tones, Voice Prompts, etc. dat files are created using the
DConvert utility (refer to the Appendix, ''Utilities'' on page 224), which converts
auxiliary source files into dat files. Some sample auxiliary source files are available in
the software package CD. These dat files are downloaded to the MG 3500 using
EMS.
Note:
12.7.1

Call Progress Tone and User-Defined Tone Auxiliary Files

The auxiliary source file for Call Progress Tones and User-Defined Tones contains the
definitions
detected/generated by the MG 3500. The Call Progress Tones are mostly used for
Telephony In-Band Signaling applications (e.g., Ring Back tone) Each tone can be
configured as one of the following types:
Continuous
Cadence (up to 4 cadences)
Burst
A tone can also be configured for Amplitude Modulated (AM) (only 8 of the Call
Progress Tones can be AM tones). The Call Progress Tones frequency range is 300
Hz to 1890 Hz.
The User-Defined Tones are general purpose tones to be defined by the user. They
can be set only as 'Continuous' and their frequency range is 300 Hz to 3800 Hz. The
maximum amount of tones that may be configured for the User Defined and Call
Progress Tones together is 32. The maximum frequencies that may be configured in
the User Defined and Call Progress Tones together is 64. The MG 3500 sample
configuration files supplied by Nortel can be used to construct your own file.
The Call Progress Tones and User-Defined Tones file used by the MG 3500 is a
binary file with the extension ".dat". Only this binary tone.dat file can be loaded to a
MG 3500. Users can generate their own tone.dat file by opening the modifiable
Installation, Operation, Maintenance Manual
b. For the static routes set the following parameters:
Destination IP
Destination Subnet Mask
Gateway IP
Protocol Group Type
Hops Count
Comment
The auxiliary source files use the same ini file extension type as the ini
configuration file, however, the functionality is different. Whenever the
term, "ini file" is used, it refers to the configuration file and NOT to the
auxiliary files.
of the Call Progress Tones and User-Defined
120
Media Gateway 3500
Tones to be
Document # LTRT-90704