Setting Clock Control To Local System - Nortel BCM50 2.0 Configuration Manual

28 Chapter 3 System Software
4 In the bottom frame, ensure that the Time zone is correct for the location of the local system.
5 If Trunk was selected in the Date and Time Source drop-down list, enter the year in the Year
field.
Note: Only time and date info are updated when NTP and Trunk
settings are selected. Year information is not updated. You also have full
control over time and date settings using telset admin even if NTP or
Trunk are selected. Any setting applied through telset admin are
over-written by the external source if NTP or Trunk are selected. Time
zones need to be set for software updates to be applied.

Setting clock control to local system

If you want the clock to be controlled locally:
1 Ensure that Date and Time Source is set to Manual.
2 In the bottom frame:
• In the Time zone field, select the Time zone the system uses.
• In the Date and time field, enter the month, day and year, hours and minutes and time of
day.
• The Daylight Savings Time check box is selected or cleared automatically, depending on
the time zone selected.
NN40020-300 NN40020-300