To Allow Last Number Redial; Saved Number Redial; Autodial; Speed Dialing - Nortel BCM50 2.0 Configuration Manual

Allowing the feature
You enable last number redial for each telephone through the restriction programming.
Configuration > Telephony > Sets > Active Sets > Restrictions tab > Allow Last Number
check box
Using the feature
Press FEATURE 5.
Note: This feature records a maximum of 24 digits.

Saved Number Redial

Use this feature to save a number from an existing call, or from an autodial button, so that you can
call the number later. Each telephone can save only one number at a time.
Allowing the feature
Enable last saved redial for each telephone through the restriction programming.
Configuration > Telephony > Sets > Active Sets > Restrictions tab > > Allow Saved Number

To allow last number redial

1
While on the call, enter FEATURE 67.
2 When your telephone is idle, enter FEATURE 67.

Autodial

You can program memory buttons for one-touch dialing of internal or external telephone numbers.
When you program an external autodial, you must specify a path out of the system. You can also
program autodial buttons with speed dial codes.
Programming DN records memory buttons for autodial:
Configuration > Telephony > Sets > All DNs > Capabilities and Preferences > Button
programming tab
For information about programming memory buttons on the telephone, refer to
memory buttons" on page

Speed dialing

BCM provides two types of speed dialing:
Chapter 25 Feature configuration: Making calls
226.
"Programming
Device Configuration Guide
225