Definitions Of Safety Warning Levels - Juniper PTX1000 Hardware Manual

Related
Documentation

Definitions of Safety Warning Levels

Copyright © 2018, Juniper Networks, Inc.
Some parts of the chassis might become hot. The following label provides the warningof
the hot surfaces on the chassis:
Always ensure that all modules, power supplies, and cover panels are fully inserted
and that the installation screws are fully tightened.
AC Power Electrical Safety Guidelines on page 136
General Electrical Safety Guidelines and Warnings on page 133
Maintenance and Operational Safety Guidelines and Warnings on page 128
Installation Instructions Warning on page 117
Grounded Equipment Warning on page 124
The documentation uses the following levels of safety warnings (there are two Warning
formats):
NOTE: You might find this information helpful in a particular situation, or you
might overlook this important information if it was not highlighted in a Note.
CAUTION: You need to observe the specified guidelines to prevent minor
injury or discomfort to you or severe damage to the device.
WARNING: This symbol alerts you to the risk of personal injury from a laser.
WARNING: This symbol means danger. You are in a situation that could cause
bodily injury. Before you work on any equipment, be aware of the hazards
involved with electrical circuitry and be familiar with standard practices for
preventing accidents.
Waarschuwing Dit waarschuwingssymbool betekent gevaar. U verkeert in
een situatie die lichamelijk letsel kan veroorzaken. Voordat u aan enige
apparatuur gaat werken, dient u zich bewust te zijn van de bij elektrische
schakelingen betrokken risico's en dient u op de hoogte te zijn van standaard
maatregelen om ongelukken te voorkomen.
Varoitus Tämä varoitusmerkki merkitsee vaaraa. Olet tilanteessa, joka voi
johtaa ruumiinvammaan. Ennen kuin työskentelet minkään laitteiston parissa,
Chapter 7: Safety and Compliance Information
113