Juniper PTX1000 Hardware Manual page 104

PTX1000 Packet Transport Router Hardware Guide
Table 31: PTX1000 Chassis Alarm Messages (continued)
Component Alarm Type
Temperature Major (red)
sensors
Minor (yellow)
Routing Engine Major (red)
Minor (yellow)
Management Major (red)
Ethernet interface
Related
Documentation
104
CLI Message
sensor-location Temp Sensor Fail
sensor-location Temp Sensor Too Hot
sensor-location Temp Sensor Too Warm
RE RE number /var partition is full
RE RE number /var partition usage is high
Management Ethernet 1 Link Down
PTX1000 Management Panel on page 30
Configuring the Junos OS to Determine Conditions That Trigger Alarms on Different
Interface Types
alarm
Recommended Action
Check the system log for the following
message and report it to customer
support:
Temp sensor sensor-number failed
sensor-number ranges from 1 through 10.
Check environmental conditions and
alarms on other devices. Ensure that
environmental factors (such as hot air
blowing around the equipment) do not
affect the temperature sensor. If the
condition persists, the device might shut
down.
For information only. Check
environmental conditions and alarms on
other devices. Ensure that environmental
factors (such as hot air blowing around
the equipment) do not affect the
temperature sensor.
Clean up the system file storage space
on the device. For more information, see
request system storage cleanup.
Clean up the system file storage space
on the device. For more information, see
request system storage cleanup.
Check whether a cable is connected to
the management Ethernet interface, or
whether the cable is defective. Replace
the cable, if required.
If the problem cannot be resolved, open
a support case.
Copyright © 2018, Juniper Networks, Inc.
, where