Juniper PTX1000 Hardware Manual page 85

Related
Documentation
Copyright © 2018, Juniper Networks, Inc.
Initiating vmhost halt... ok
Initiating Junos shutdown...
Shutdown NOW!
ok
Junos shutdown is in progress...
*** FINAL System shutdown message
System going down IMMEDIATELY
...
...
Operating system halted.
Please press any key to reboot.
CAUTION: Although traffic and the operating system have stopped, the
PTX1000 PSM LEDs remain lit and a fan module continues to run. Wait
at least 60 seconds after first seeing this message before following the
instructions in Step
To prevent damage to the equipment caused by static discharge, attach an
3.
electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the
strap to one of the ESD points on the chassis.
Disconnect power to the PTX1000:
4.
AC power supply—If the AC power source outlet has a power switch, set it to the
off ( O ) position. If the AC power source outlet does not have a power switch, gently
pull out the male end of the power cord connected to the power source outlet.
DC power supply—Switch the circuit breaker on the panel board that services the
DC circuit to the off position.
Remove the power source cable from the power supply faceplate:
5.
AC power supply—Gently pull out the female end of the power plug connected to
the power supply faceplate.
DC power supply—Loosen the thumb screws for the power cable. Gently pull out
the female end of the power plug connected to the power supply faceplate.
Uninstalling the PTX1000 on page 99
Chapter 3: Initial Installation and Configuration
shutdown: [pid 14318]
***
4 and Step 5 to power off the PTX1000.
85