[2.08.3] Execute Calibrations; [2.08.3.1] Use Calibration Pool - Siemens SIPROCESS GA700 Operating Manual

Functions
6.7 [2.08] Settings > Calibrations
6.7.5

[2.08.3] Execute calibrations

6.7.5.1

[2.08.3.1] Use calibration pool

Overview
If you want to execute a calibration/validation with a specifically selected calibration pool
entry, you can use this menu. The wizard-driven calibration/validation can be used any
number of times. In contrast to a calibration, calibration parameters are not changed during a
validation.
For additional information, see also:
→ Overview (Page 129)
→ Executing calibrations/validations by means of a calibration pool entry (Page 128)
Executing calibrations/validations by means of a calibration pool entry
Requirements
The calibration pool has one or more entries: Assigning parameters for calibration pool
entries (Page 126).
Procedure
1. Main menu > "2. Settings" > "08. Calibrations" > "3. Execute calibrations" > "1. Use
calibration pool"
In this menu you start a previously-assigned calibration or validation from the calibration
pool.
2. Select calibration pool entry: "Selected calibration" parameter field
– Authorize access with Standard PIN, if necessary.
– Select one of the offered calibration pool entries in the displayed editing window.
– After the selection, the parameter assignment of the calibration pool entry is displayed.
3. Start the wizard for a calibration or validation.
– "Start validation" parameter field
– "Start calibration" parameter field
Follow the instructions on the display.
See also
Overview (Page 128)
128
A validation evaluates the current device status with respect to the last calibration. The
need for a new calibration can be derived from the validation results.
Operating with the Local User Interface
Operating Manual, 06/2017, A5E31930478-05