Assigning User Func Key; [2.02] Settings > Time/Date; Setting The Time And Date - Siemens SIPROCESS GA700 Operating Manual

Functions
6.3 [2.02] Settings > Time/Date
6.2.6

Assigning USER FUNC key

Procedure
You can assign two functions to the <USER FUNC> key:
1. Main menu > "2 Settings" > "01 Display/USER FUNC key" > "6 USER FUNC key"
2. Call the parameter display: Press <Enter>.
3. Assign the key: "Assign function" parameter field. Authorize access with Standard PIN, if
necessary.
The following functions can be set:
– Acknowledge current messages:
6.3 [2.02] Settings > Time/Date
6.3.1

Setting the time and date

Procedure
Note
Effects of changes
Changing the time has a direct effect on the sequence of logbook entries and all other time-
based device services.
Check the logbook entries following changes to this setting. If necessary, reset the
parameters of the logbook filter function.
1. Main menu > "2 Settings" > "02 Time/Date"
2. Specify display format of the date: "Date format" parameter field.
This parameter field can be edited without PIN input.
3. Enter the current date: "Date" parameter field.
Authorize access with Standard PIN, if necessary.
102
All pending messages get the status "acknowledged".
With this function you do not have to call the message list in the main view and follow
the menu-guided acknowledgment procedure. If you have not yet remedied the reason
for the message at the time of acknowledgment, the corresponding message is still
pending after acknowledgment.
Operating with the Local User Interface
Operating Manual, 06/2017, A5E31930478-05