Setting Limits - Siemens SIPROCESS GA700 Operating Manual

Functions
6.5 [2.04] Settings > Limits
Monitoring options
The following monitoring options can be used:
Table 6- 2
Monitoring
None
Low limit violated
High limit exceeded
LImit violated at "Value outside"
LImit violated at "Value within"
See also
Setting limits (Page 108)
6.5.2

Setting limits

Procedure
Note
Effects
Changing the parameter setting has a direct effect on the following functions:
• Status bar: Display of system messages
• Logbook: entries in the device logbook
• Digital measured value status
Note
Component-specific setup
Limit ranges are component-specific. Repeat the procedure described below for all
components, if necessary.
108
Monitoring options using limits
Setting
The low and high limits are inactive: Setting "Off"
for both.
Only the low limit is activated.
Only the high limit is activated.
The low and high limits are activated. Limit viola-
tion: The measured value is located outside the
interval.
The low and high limits are activated. Limit viola-
tion: The measured value is located within the
interval.
Operating with the Local User Interface
Operating Manual, 06/2017, A5E31930478-05