Daikin Emura RXJ20A5V1B Service Manual page 93

To remove the front panel motor wiring harness
RXJ20~50A + FTXJ-A(W)(S)(B)
Split Emura 3 R32
ESIE22-04B – 2022.08
b
a Connector
b Connector holder
c Screw (front panel motor gearcase assy)
d Front panel motor gearcase assy
2 Install the 2 screws to fix the front panel motor and gears assembly. Do NOT
yet tighten the screws.
3 Make sure the lever is correctly connected (using soft tools) at the front side
of the front grille.
4 Tighten the 2 screws to fix the front panel motor and gears assembly.
5 Place the connector in the connector holder.
6 Install front grille and assemble the indoor unit, see
Is the problem solved?
Yes
No
Prerequisite: Stop the unit operation via the user interface.
Prerequisite: Turn OFF the respective circuit breaker.
1 Remove the required plate work, see
2 Remove the switch box from the indoor unit, see
3 Remove the wifi control PCB from the switch box, see
4
procedures" [ 177].
4 Disconnect the front panel motor wiring harness from the indoor unit main
PCB and from the switch box.
d c
a c
Action
No further actions required.
Return to the troubleshooting of the
specific error and continue with the
next procedure.
"4.14 Plate
4 Components
|
4
"4.14 Plate work" [ 144].
4
work" [ 144].
4
"4.14 Plate work" [ 144].
"4.20.2 Repair
Service manual
93