Daikin Emura RXJ20A5V1B Service Manual page 163

Repair procedures
To remove the swing flap motor gearcase assembly
To install the swing flap motor gearcase assembly
RXJ20~50A + FTXJ-A(W)(S)(B)
Split Emura 3 R32
ESIE22-04B – 2022.08
INFORMATION
To replace the motor, the complete gearcase assembly MUST be replaced.
Prerequisite: Stop the unit operation via the user interface.
Prerequisite: Turn OFF the respective circuit breaker.
Prerequisite: Remove the required plate work, see
1 Remove the main swing flap from the indoor unit (by clicking it out).
2 Remove the 2 screws and remove the swing flap motor gearcase assembly
from the indoor unit.
a Screw
b Swing flap motor gearcase assembly
3 Disconnect the swing flap motor harness from the swing flap motor.
4 To install the swing flap motor gearcase assembly, see
procedures" [ 4 163].
1 Connect the swing flap motor harness to the swing flap motor connector.
2 Install the swing flap motor gearcase assembly on the indoor unit and tighten
using the 2 screws.
a Screw
b Swing flap motor gearcase assembly
4
"4.14 Plate work" [
a
a b
a
a b
Components
|
4
144].
"Repair
Service manual
163