Removing A 264If-01 Module - YASKAWA 264IF-01 User Manual

3.2.2 Removing a 264IF-01 Module

Use the following procedure to remove a 264IF-01 Module.
( 1 ) Preparation
1.
Backup the Programs.
Save the programs written to the Machine Controller in the personal computer using MPE720.
 MPE720 Ver. 7.: Open the project file and then select Online - Transfer - Read from Controller.
2.
Remove the Machine Controller and Expansion Rack.
Turn OFF the power supply and remove the cables connected to the Machine Controller or Expansion Rack.
Then, remove the Machine Controller and Expansion Rack from the panel or rack and place them where there is
sufficient space, such as on a work table.
( 2 ) Removing Procedures
1.
Remove the Battery Cover.
<MP2200/MP2300/MP2200 Base Unit>
Pull the notch on the side toward you to remove the
battery cover.
2.
Remove the Option Panel.
Hold the battery cover with the front facing forward, insert the protrusion on the battery cover into the notch at
the top of the Module's option panel, and release the hook on the option panel.
Release the hook on the bottom in the same way and remove the option panel.
3.2 Mounting and Removing a Module on the Machine Controller

3.2.2 Removing a 264IF-01 Module

<MP2310/MP2300S>
Insert a finger in the lug on the lower part of the bat-
tery cover as shown in the figure and remove the
battery cover.
3
3-7