Cable And Connector Specifications For The Acx6160 - Juniper ACX6160 Hardware Manual

third-party optical module or cable and, if required, replace it with an equivalent
Juniper-qualified component.
Use of third-party optical modules with high-power consumption (for example,
coherent ZR or ZR+) can potentially cause thermal damage to or reduce the lifespan of
the host equipment. Any damage to the host equipment due to the use of third-party
optical modules or cables is the users' responsibility. Juniper Networks will accept no
liability for any damage caused due to such use.

Cable and Connector Specifications for the ACX6160

IN THIS SECTION
LC Duplex Connectors | 37
The transceivers that are supported on ACX Series, MX Series, and PTX Series devices use fiber-optic
cables and connectors. The type of connector and the type of fiber depends on the transceiver type.
You can determine the type of cable and connector required for your specific transceiver by using the
Hardware Compatibility Tool.
CAUTION: To maintain agency approvals, use only a properly constructed, shielded
cable.
LC Duplex Connectors
You can use patch cables with LC duplex connectors to connect two supported transceivers of the same
type—for example, 100GBASE-LR4-to-100GBASE-LR4. The patch cable is one fiber pair with two LC
duplex connectors at opposite ends.
37