Registering Products-Mandatory For Validating Slas; Configuring A Qfx10000 - Juniper QFX10002 Hardware Manual

QFX10002 Switch Hardware Guide
Related
Documentation
Registering Products—Mandatory for Validating SLAs

Configuring a QFX10000

106
NOTE: The switch powers on as soon as power is provided to the power
supply. There is no power switch on the device.
Verify that the LED on the power supply is lit green and is on steadily.
8.
If the status LED is lit amber, remove power from the power supply, and replace the
power supply (see "Removing a Power Supply from a QFX10002" on page
not remove the power supply until you have a replacement power supply ready. The
power supplies must be installed in the QFX10002 to ensure proper airflow.
CAUTION: Replace a failed power supply with a new power supply within
30 seconds of removal to prevent chassis overheating.
QFX10002 Management Panel on page 44
RJ-45 Management Port Connector Pinout Information on page 80
QFX10002 Power System on page 55
Register all new Juniper Networks hardware products and changes to an existing installed
product using the Juniper Networks website to activate your hardware replacement
service-level agreements (SLAs).
CAUTION: Register product serial numbers on the Juniper Networks website
and update the installation base data if there is any addition or change to
the installation base or if the installation base is moved. Juniper Networks
will not be held accountable for not meeting the hardware replacement
service-level agreement for products that do not have registered serial
numbers or accurate installation base data.
Register your product(s) at:
Update your install base at:
https://www.juniper.net/customers/csc/management/updateinstallbase.jsp
You must perform the initial configuration of a QFX10000 modular switch through the
console port using the command-line interface (CLI) or through Zero Touch Provisioning
(ZTP). On QFX10002 fixed-chassis models, in addition to using the CLI, you may also
use ZTP. In order to provision the QFX10002 using ZTP, you must have access to a
Dynamic Host Control Protocol (DHCP) server and a File Transfer Protocol (anonymous
https://tools.juniper.net/svcreg/SRegSerialNum.jsp
Copyright © 2019, Juniper Networks, Inc.
113). Do
.
.