Overview; Figure 6: Qfx10002-36Q Port Panel; Table 8: Qfx10002-36Q Port Capacities - Juniper QFX10002 Hardware Manual

QFX10002 Switch Hardware Guide

Table 8: QFX10002-36Q Port Capacities

Per Port Group
1 x100 Gbps
3 x 40 Gbps
12 x 10 Gbps
28
100-Gbps Operation and Configuration on page 29
40-Gbps Channelization on page 30
Port Mapping on page 31

Overview

Any of the 36 ports 0 through
Figure 6 on page 28.

Figure 6: QFX10002-36Q Port Panel

1— Management panel
The default configuration is independent 40-Gigabit Ethernet for all 36 ports. For
100-Gbps or 10-Gbps channelization operation, the ports operate within port groups.
Every three ports compose a port group. See
through Figure 10 on page
The second and sixth port in each 6XQSFP+ socket can be configured to support:
100-Gigabit Ethernet using 28-Gbps QSFP28 optical transceivers and 100-Gbps active
optical cables (AOCs). When a QSFP28 transceiver is inserted into the ports marked
with a fine black line underneath the socket and the port is configured for 100-Gigabit
Ethernet, the two adjacent ports are disabled and the QSFP28 is enabled for 100-Gigabit
Ethernet.
40-Gigabit Ethernet using QSFP+ optical transceivers or 40-Gbps direct attach copper
(DAC) cables.
35 can be configured as either uplink or network ports. See
2
2— Port panel with QSFP+ network interface
or uplink ports (36)
Table 8 on page 28
31.
Per Switch
12 x 100 Gbps
36 x 40 Gbps
144 x 10 Gbps
1
and Figure 7 on page 30
Copyright © 2019, Juniper Networks, Inc.