Remote Configuration Of Several Devices; Introduction - Siemens SIMATIC HMI Industrial Thin Client ITC1200 Operating Instructions Manual

Assigning device parameters

5.4 Remote configuration of several devices

Adjusting the display in the web browser
You can enlarge or reduce the display in the web browser:
● Use the key combination <CTRL><+> to enlarge the display.
● Use the key combination <CTRL><-> to reduce the display.
Note
Depending on the keyboard you are using, it may be necessary to press the Shift key to
access the "+" and "-" keys. In this case, use <Control><Shift><+> to enlarge the display
and <Control><Shift><-> to reduce it.
See also
Opening the configuration (Page 35)
5.4 Remote configuration of several devices
5.4.1

Introduction

Introduction
Remote Configuration Center (RCC) enables remote configuration and remote update of
SIMATIC Industrial Thin Clients from a PC that is connected to the Industrial Thin Clients via
a network. This chapter describes:
● The requirements and mechanisms for remote configuration and remote update
● The operation
Area of application
You can perform the following actions from a central PC for one or more Industrial Thin
Clients:
● Edit configuration settings
● Back up and restore the configuration
● Identifying a device
● Change IP addresses
● Update firmware
● Generate a key pair
● Restart devices
66
Industrial Thin Client ITC1200, ITC1500, ITC1900, ITC2200
Operating Instructions, 04/2013, A5E03474888-02