Table of Contents
Advertisement
7.3.4
Terminating a connection
Introduction
You can terminate a client-server connection as follows:
● Using the "Close" menu command (see below).
● For more options refer to "Special features".
Procedure
Proceed as follows to terminate an active client-server connection:
1. Touch the "Connection list" icon in the taskbar. A list of all started client-server
2. Choose the "Close" menu command next to the connection.
3. If required, enter the connection password (see section "Password settings (Page 58)").
Special features
RDP
Note
Terminate the RDP connection alternatively by using "Start" > "Disconnect". The "RDP
session has been terminated by peer!" dialog box will be displayed on the device;
acknowledge it with "OK". The connection password is not requested.
You log off from the RDP server with "Start" > "Logoff".
SINUMERIK
The connection to the SINUMERIK system network is terminated. The network settings are
reset to the values they had before the SINUMERIK connection was started.
See also
Starting a connection (Page 91)
Industrial Thin Client ITC1200, ITC1500, ITC1900, ITC2200
Operating Instructions, 04/2013, A5E03474888-02
connections opens.
Note
Misuse
RDP can be set on the server so that the user stored in the connection settings remains
logged in even after an RDP connection has been terminated.
Make sure that only authorized persons have access to the device or log off (see Special
features).
Administrator password
You can also enter the administrator password instead of the connection password.
Operating the device
7.3 Operating the taskbar
93
Advertisement
Table of Contents
