Connecting The Device; Overview - Siemens SIMATIC HMI Industrial Thin Client ITC1200 Operating Instructions Manual

Installing and connecting the device

3.4 Connecting the device

3.4 Connecting the device
3.4.1

Overview

Requirement
● The device has been installed according to the information provided in these operating
● Always use shielded standard cables.
For order information please refer to Industry Mall (http://mall.automation.siemens.com).
Connection sequence
Connect the device in the following sequence:
1. Equipotential bonding
2. Power supply
3. PROFINET/Ethernet
4. I/Os as necessary
Disconnect the device by completing the above steps in reverse order.
Connecting the cable
● When connecting the cables, ensure that the contact pins are not bent.
● Secure the cable connector with a cable tie.
● Provide adequate strain relief for all cables.
● The pin assignment of the interfaces is described in the technical specifications.
See also
Power supply (Page 117)
USB (Page 117)
26
instructions.
CAUTION
Damage in case of incorrect connection sequence
You must connect the device in the sequence indicated above.
Industrial Thin Client ITC1200, ITC1500, ITC1900, ITC2200
Operating Instructions, 04/2013, A5E03474888-02