Table of Contents
Advertisement
Manual for installation of the Sensformer® Connectivity Device
3. Configuration
The Sensformer Connectivity Device configuration can be done
through the graphical user interface (GUI) "Settings" page.
On this page the following parameters can be set:
•
analog sensors,
•
digital sensors,
•
system parameters,
•
MQTT and M2M parameters,
•
NTP time servers,
•
Calibration done.
NOTE
The default local IP address of the Sensformer Connectivity
Device graphical user interface (GUI) is
The web GUI can be reached with this address in web browsers.
3.1
Analog sensors
3.2
Digital sensors
3.3
System values
3.4
MQTT and M2M
3.5
NTP Time servers
3.6
LAN/WAN modes
3.7
Calibration done
https://192.168.1.1
© 2020 Siemens Energy
Page 14
Advertisement
Table of Contents
