Sinumerik - Siemens SIMATIC HMI Industrial Thin Client ITC1200 Operating Instructions Manual

Hmi device

Table of Contents

6.4

SINUMERIK

Introduction

The DHCP server is enabled on each SINUMERIK server by default. The SINUMERIK

system network therefore configures itself dynamically via the DHCP protocol. Additional

information is available in the "SINUMERIK manual "Operator components and networking"

(6FC5397-1AP10-5AA0) (http://www.automation.siemens.com/doconweb/)".

USB stick for commissioning

You use a button on the HMI user interface of the SINUMERIK TCU to access the USB port

on the rear of the device. For example, you read in the series startup files on the

SINUMERIK USB stick. A maximum of one USB storage device is accessed which is

recognized first.

Note

Security threat to the system

The USB may infect the server with viruses, Trojans, spam, etc.

Use a suitable virus scanner to check the data on the USB storage medium or disable the

HMI button for access via USB.

The USB port is only available if you make the following settings for the corresponding

button in the SINUMERIK menu "Commission > HMI > Logical drive":

● "Type" = "USB local"

● "Connection" = "X204"

Keyboard language with external keyboard

Damage to the machine or plant through operating error

The set system language, for example German, also determines the keyboard language of

the externally connected USB keyboard. If you then connect an English keyboard, however,

such as is the case with a SINUMERIK connection, the keys do not have the same

meaning as is printed on them.

This may result in operating errors at the machine and personal injury or damage to the

machine or plant. To connect an English keyboard, set the system language to English

under "Language" in the Start menu "Configuration > System".