Table of Contents
Advertisement
Installing and connecting the device
3.2 Preparing for installation
3.2
Preparing for installation
Select the mounting location of the HMI device
Points to observe when selecting the mounting location:
● Position the HMI device so that it is not subjected to direct sunlight.
● Position the HMI device such that it is ergonomically accessible for the operator.
● Ensure that the air vents of the HMI device are not covered as a result of the mounting.
● Note the permissible mounting positions.
3.2.1
Checking the package contents
Check the package content for visible signs of transport damage and for completeness.
Note
If a part is damaged
A damaged part will cause the HMI device to malfunction.
Do not install parts damaged during shipment. In the case of damaged parts, contact your
Siemens representative.
The following is included in the scope of delivery of the device:
● The device itself
● Accessory kit with mounting clamps and mains terminal
● CD with RCC remote configuration software and the source codes for the open source
● Additional documents as required
The documentation belongs to the device and is required for subsequent commissioning.
Retain all enclosed documentation for the entire service life of the HMI device. You must
pass on the enclosed documentation to any subsequent owner or user of the HMI device.
Make sure that every supplement to the documentation that you receive is stored together
with the operating instructions.
20
Choose a suitable mounting height.
software
Industrial Thin Client ITC1200, ITC1500, ITC1900, ITC2200
Operating Instructions, 04/2013, A5E03474888-02
Advertisement
Table of Contents
