Starting A Connection - Siemens SIMATIC HMI Industrial Thin Client ITC1200 Operating Instructions Manual

7.3.2

Starting a connection

Overview
From the Industrial Thin Client, you can establish a connection to a server with the
configured connection settings. The following connection types are supported:
● RDP
● Sm@rtServer/VNC
● SINUMERIK: Bootloader and Viewer are started. A selection menu with the "Open"
● Web: besides the web connection, additional web settings are required for the web
You can also open the web browser separately in order to connect to the Internet.
Procedure for client-server connection
Proceed as follows to establish a client-server connection:
1. Touch the
2. Select a client-server connection.
The configured connection to the server or system network will be started.
Procedure for web browser
Proceed as follows to establish a connection to the Internet or an intranet:
1. Select the "Web browser" menu command in the taskbar of the
browser will open.
2. Specify a valid Internet address in the address line of the web browser.
Industrial Thin Client ITC1200, ITC1500, ITC1900, ITC2200
Operating Instructions, 04/2013, A5E03474888-02
command is displayed.
browser that displays the web connection.
Note
Limited number of client-server connections
A maximum of 5 client-server connections can be started at the same time. If a sixth
connection is activated, an error message appears.
Only one SINUMERIK connection can be started at any one time. The screen can no
longer be operated when you activate a second connection.
"Favorites" icon in the taskbar.
The IP address of the device is stored as the home page. The home page displays
important device data and network settings.
Operating the device
7.3 Operating the taskbar
Start menu. The web
91