Table of Contents
Advertisement
Technical specifications
9.4 Technical specifications
9.4.2
Performance data
Performance values
The performance depends on the network capacity in your system. With the SIMATIC
WinCC Sm@rtServer option, the performance varies within the values specified in the
WinCC documentation.
See also
FAQ 25576569 (http://support.automation.siemens.com/WW/view/en/25576569)
9.4.3
Ambient conditions
9.4.3.1
Transport and storage conditions
Mechanical and climatic conditions for transportation and storage
The requirements regarding transport and storage conditions for the device are more
stringent than those laid down in IEC 61131-2. The following requirements apply to the
transport and storage of the device in its original packaging.
The climatic conditions conform to the following standards:
● IEC 60721-3-2, Class 3K7 for storage
● IEC 60721-3-2, Class 2K4 for transport
The mechanical conditions correspond to IEC 61131-2.
Type of condition
Drop test (in transport package)
Temperature
Atmospheric pressure
Relative humidity
Sinusoidal vibration in accordance with
IEC 60068-2-6
Shock in accordance with IEC 60068-2-29
Note
Avoid dewing
If the HMI device is subjected to low temperatures or extreme fluctuations in temperature
during transportation, moisture could occur on or inside the HMI device. Dewing can occur.
This can cause malfunctions.
The device must be brought to room temperature before it is commissioned. Do not expose it
to direct heat radiation from a heating device. If there is condensation, wait approximately
4 hours until the device has dried completely before switching it on.
Proper transport and storage, installation and assembly as well as careful operation and
maintenance are prerequisites for trouble-free and safe operation of the device.
Non-compliance shall result in the voiding of the device warranty.
112
Permitted range
≤ 1 m
From –20 to +60° C
From 1080 to 660 hPa,
Corresponds to an elevation of –1 000 to 3 500 m
From 10 to 90%, without condensation
5 to 8.4 Hz: 3.5 mm
8.4 to 500 Hz: 9.8 m/s
2
250 m/s
, 6 ms, 1000 shocks
2
Industrial Thin Client ITC1200, ITC1500, ITC1900, ITC2200
Operating Instructions, 04/2013, A5E03474888-02
Advertisement
Table of Contents
