Perform Action - Siemens SIMATIC HMI Industrial Thin Client ITC1200 Operating Instructions Manual

Assigning device parameters
5.4 Remote configuration of several devices
5.4.4.2

Perform action

Procedure
Note
Actions only one after the other
You can only perform one action after another on a device. Before performing an action on a
device, wait until the actions on all selected devices have been completed.
Proceed as follows to perform an action:
1. Select one or more devices in the device window. To select all devices, touch the "Select
2. Select an available action, for example in the action bar.
Note
Unavailable buttons are grayed-out
Certain actions cannot be performed at every point. The corresponding buttons are then
grayed out.
3. Wait until all devices have been processed.
4. Check the status in the device list.
5. Use the "Done" button to close the action dialog if it does not close automatically.
Now you can perform the next action.
Status
The status describes the outcome of the last action that was performed on this device (see
section "Status (Page 75)").
74
all" icon.
The action is performed on all selected devices. An action dialog with the list of the
processed devices and the current status is displayed.
Industrial Thin Client ITC1200, ITC1500, ITC1900, ITC2200
Operating Instructions, 04/2013, A5E03474888-02