Standard Connecting Cables That Can Be Connected To Connector X1 - Siemens SIMATIC NET SINAUT ST7 System Manual

Installing and putting a TIM into operation
5.3 Design of the TIM 3 and TIM 4 modules
5.3.5

Standard connecting cables that can be connected to connector X1

An external modem or other transmission device can be connected to the 9-pin X1 connector
of the combined RS-232/RS-485 port.
To connect to connector X!, the following standard connecting cables are available.
Table 5-14 Connectable standard cables for all TIM 4 modules
Order no. Description
6NH7701-4AL Cable for connecting the TIM 3V-IE (RS-232) to one of the
SINAUT ST7 modems MD2, MD3 or MD4 (RS-232).
Also suitable for linking these modems to a SIMATIC point-
to-point CP such as the CP 340, CP 341 or CP 441 with
RS-232 interface.
Cable length 1.5 m
6NH7701-4DL Cable for connecting a TIM 4R-IE / TIM 4 (RS-485) with
multiple SINAUT ST7 dedicated line modems connected in
parallel of the type MD2 or MD3 (RS-485).
Cable length 1.5 m
6NH7701-5AN Cable for connecting the TIM (RS-232) to the GSM modem
MC45 or MD720-3 (RS-232). Also suitable for third-party
modems or wireless devices with RS-232 standard.
Cable length 2.5 m
6NH7701-4BN Cable with one end without connector for connecting the
TIM (RS-232) to a third-party modem or wireless device
(RS-232)
Cable length 2.5 m
6NH7701-0AR Test cable.
Cable for connecting two TIM 3V-IE / TIM 4 / TIM 4R-IE
modules over their RS-232 ports without modems (null
modem).
Cable length 6 m
If an MD2 or MD3 dedicated line modem is connected to the X1 connector, it is possible to
operate several of these dedicated line modems connected in parallel over this connector
172
Illustration
SINAUT ST7 Station control system - System Manual
System Manual, 05/2007, C79000-G8976-C178-06