Table of Contents
Advertisement
Factory setting on the DIL switch
When it ships, the modem has the following default settings:
● Standard profile 0: AT mode
● Reset OFF
When shipped, the switches are set as shown in the following figure.
6.7.3
Connectors and configuration switches accessible from below
The following figure shows the MD4 modem from below with the X3 RJ-12 Western jack and
the DIL switch for activating the RS-232 or RS-485 interface.
Figure 6-51
SINAUT ST7 Station control system - System Manual
System Manual, 05/2007, C79000-G8976-C178-06
View of the MD4 modem from below
Installing and putting a SINAUT modem into operation
6.7 ISDN dial-up modem MD4
307
Advertisement
Table of Contents
