Siemens SIMATIC NET SINAUT ST7 System Manual page 89

Figure 2-24 The WAN manager for SINAUT ST7
When necessary, the properties dialog of a TIM module can also be opened in
have the same configuration options as in
The SINAUT ST7 configuration tool
Unlike the two managers mentioned up to now, the SINAUT ST7 configuration tool does not
expand one of the standard STEP 7 tools but is a separate configuration tool embedded in
the STEP 7 environment. This allows you to perform the remaining SINAUT-specific
configuration tasks. It consists of the following:
● Connection configuration
● Subscriber administration
● SINAUT ST1 - Configuration Overview
The first step is to use the
(ST7-CPU, ST7cc/ST7sc or ST1 device) between which a connection is necessary. The tool
provides you with a selection of all theoretically possible connections in the right-hand pane
of the split window. These are determined automatically by the tool based on the network
configured with NetPro (see WAN manager). The user then selects the required connections
and copies them to the left-hand pane using the context menu.
SINAUT ST7 Station control system - System Manual
System Manual, 05/2007, C79000-G8976-C178-06
2.9 The SINAUT ST7 standard software package
HW Config
Connection configuration
Introduction to the SINAUT ST7 system
.
tool to specify the SINAUT subscribers
NetPro
. You
89