Table of Contents
Advertisement
Installing and putting a SINAUT modem into operation
6.8 Installing and putting a SINAUT MD2, MD3, MD4 modem into operation
6.7.4
Connecting the MD4 with a TIM and ISDN outlet
The following figure summarizes how the MD4 modem is connected to a TIM (over RS-232)
and with the ISDN outlet (S
Figure 6-53
Note
Any TIM with an RS-232 port can be used, in other words, the two TIM 3V-IE variants, the
TIM 4R-IE and the TIM 4.
6.8
Installing and putting a SINAUT MD2, MD3, MD4 modem into
operation
Introduction
The MD2, MD3 and MD4 modems can be installed on a SIMATIC S7-300 rail or using the
6NH7760-0AA adapter (must be ordered separately) on a 35 mm standard rail.
The modem can be operated both in a horizontal and in a vertical installation.
Note
Before the modem is installed on the S7-300 or standard rail, all the DIL switches of the
modem must be set correctly for operation. These switches are practically inaccessible when
the module is installed.
310
) using the specified standard connecting cables.
0
Connecting the MD4 with a TIM and ISDN outlet (S
)
0
SINAUT ST7 Station control system - System Manual
System Manual, 05/2007, C79000-G8976-C178-06
Advertisement
Table of Contents
