Table of Contents
Advertisement
Installation guide
3.8 Standalone TIM 4 with an S7-400 or PC
S7-300 with maximum configuration
The maximum number of TIMs that can installed in an S7-300 depends on the connection
resources provided by the CPU. Two connection resources per TIM are required on the
CPU.
Apart from the connection resources, the available work memory on the CPU must also be
taken into consideration. The more TIMs installed and the more stations connected and the
more objects processed per station, the greater the memory requirements of the telecontrol-
specific user program on the CPU. This program is put together with blocks from the
SINAUT TD7 software package (TD7onCPU).
3.8
Standalone TIM 4 with an S7-400 or PC
Introduction
In standalone mode, in other words, without an S7-300-CPU, the TIM 4 is ideally suited as a
SINAUT communications processor for a SIMATIC S7-400 or for the PC of the ST7cc or
ST7sc control center. They are then linked over the MPI port of the TIM 4.
Installation
When used as a standalone, the TIM 4 is normally installed on a separate S7-300 standard
rail, when necessary along with a power supply module to supply the TIM with 24 V. If the
SINAUT MD2, MD3 or MD4 modems are used, they can also be installed on the same rail.
The bus module connector supplied with every TIM is not required here since the TIM and
modem are always interconnected over the 6NH7701-xxx connecting cable.
TIM 4 with SIMATIC S7-400
All the S7-400 CPUs listed below are suitable for connecting the TIM 4 over MPI. The list
also includes older CPU types that can no longer be ordered as new devices but that
nevertheless may still be in use in the field. These are shown in parentheses.
CPU 412-1
CPU 412-2
(CPU 413-1)
(CPU 413-2)
(CPU 414-1)
CPU 414-2
CPU 414-3
(CPU 416-1)
CPU 416-2
CPU 416-3
CPU 416F-2
CPU 417-4
Fault-tolerant SINAUT solutions with a CPU 414-4H or CPU 417-4H are not possible!
1)
140
as of 6ES7 412-1XF00-0AB0
as of 6ES7 412-2XG00-0AB0
as of 6ES7 413-1XG00-0AB0
as of 6ES7 413-2XG00-0AB0
as of 6ES7 414-1XG00-0AB0
as of 6ES7 414-2XG00-0AB0
as of 6ES7 414-2XJ00-0AB0
as of 6ES7 414-3XJ00-0AB0
1)
as of 6ES7 416-1XJ00-0AB0
as of 6ES7 416-2XK00-0AB0
(as of 6ES7 416-2XL00-0AB0)
as of 6ES7 416-3XL00-0AB0
as of 6ES7 416-2FK02-0AB0
as of 6ES7 417-4XL00-0AB0
1)
(Version 02)
(Version 01)
(Version 02)
(Version 03)
(Version 02)
(version 03)
(version 01)
(Version 01)
(Version 02)
(version 01)
(version 01)
(Version 01)
(Version 01)
SINAUT ST7 Station control system - System Manual
System Manual, 05/2007, C79000-G8976-C178-06
Advertisement
Table of Contents
