Siemens SIMATIC NET SINAUT ST7 System Manual page 40

Introduction to the SINAUT ST7 system
2.3 SINAUT TIM communication modules
TIM 33
Integrated modem MD3
Transmission path
Available ITU transmission standards
Metering pulse filter can be adjusted to
Dialing mode
Loop power section
Loudspeaker
Line adjustment
Approvals
Compatible with SINAUT modems
•
•
•
The use of TD7onCPU over backplane bus is possible with the following CPU types:
1)
All variants of the CPU 313C, CPU 314 and CPU 314C;
the CPU 315-2 DP and the CPU 315F-2 DP;
all variants of the C7 devices C7-633, C7-635 and C7-636
The MPI ports of the S7-300-CPU can be used with the following CPU types:
2)
All variants of the CPU 312, CPU 312C, CPU 314 and CPU 314C;
the CPU 315-2 DP and the CPU 315F-2 DP
40
MD125
MDM2425B DX
MD3 (hardware version < 4)
Analog dial-up telephone network
V.22 1200 bps, duplex
•
V.22bis 2400 bps, duplex
•
V.32bis 4800 bps, duplex
•
V.32bis 9600 bps, duplex
•
V.32bis 14400 bps, duplex
•
V.34bis 19200 bps, duplex
•
V.34bis 33600 bps, duplex
•
12 kHz
•
16 kHz
•
Tone dialing
•
Pulse dialing
•
Exists, can be switched in or out
Exists, can be switched on or off
600 ohms
•
Zr (frequency-dependent)
•
Europe
•
USA
•
Canada
•
- V.22 1200 bps, duplex
•
- V.22bis 2400 bps, duplex
V.22bis 2400 bps, duplex
•
- V.22 1200 bps, duplex
•
- V.22bis 2400 bps, duplex
- V.32bis 4800 bps, duplex
- V.32bis 9600 bps, duplex
- V.32bis 14400 bps, duplex
SINAUT ST7 Station control system - System Manual
System Manual, 05/2007, C79000-G8976-C178-06