Siemens SIMATIC NET SINAUT ST7 System Manual page 279

Table 6-31
Profile no.
0
1
2
3
4
5
6
7
Basic settings for dedicated line mode
Certain basic settings must be made for the dedicated line mode. The settings relate to the
data format, the modem type, and line adjustment. You make the basic settings with the DIL
switches SW2.1, SW2.5, SW2.6 and SW2.9.
The procedure is as follows:
Turn of the power supply and set the four switches mentioned above to the required position.
When you turn on the power supply, the modem then adopts the selected basic setting.
SINAUT ST7 Station control system - System Manual
System Manual, 05/2007, C79000-G8976-C178-06
Setting standard dialing profiles
Meaning
AT mode
V.25bis
1200 bps duplex, V.22
V.25bis
2400 bps duplex, V.22bis
V.25bis
4800 bps duplex, V.32bis
V.25bis
9600 bps duplex, V.32bis
V.25bis
19200 bps duplex, V.34bis
V.25bis
33600 bps duplex, V.34bis
AT mode
Freely configurable
Installing and putting a SINAUT modem into operation
6.6 Analog dial-up modem MD3
Setting on DIL switch
279