Table of Contents
Advertisement
13 WHEELS, TIRES
13.2
88
Installing the front wheel
Warning
Danger of accidents Oil or grease on the brake discs reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when necessary.
H00935-10
G04198-10
G04194-11
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change front wheel bearing.
–
Clean and grease shaft seal rings
A
surfaces
of the spacers.
Long-life grease (
p. 134)
–
Insert the spacers.
Info
Insert the wide spacer on the brake disc side.
Insert the narrow spacer on the opposite side.
–
Clean and grease the wheel spindle.
Long-life grease (
p. 134)
–
Position the front wheel and insert the wheel spindle.
–
Mount and tighten screw
Guideline
Screw, front wheel
spindle
–
Position the brake caliper. Mount screws
4
ers
but do not tighten yet.
The brake linings are correctly positioned.
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point. Secure the hand brake lever in the activated position.
The brake caliper straightens.
–
3
Tighten screws
.
Guideline
Screw, front
M10
brake caliper
–
Remove the locking piece of the hand brake lever.
1
and contact
2
.
M20x1.5
35 Nm (25.8 lbf ft)
3
with wash-
45 Nm (33.2 lbf ft)
Loctite
®
243™
Advertisement
Table of Contents
