Moving And Copying Nc Unit Data - Omron SYSMAC W398-E1-1 Operation Manual

Basic Operations
2-3-5

Moving and Copying NC Unit Data

Moving NC Unit Data
22
Shortcut keys are allocated to some functions. These allocations are dis-
played on the right side of the menu. For example, New can be selected by
pressing the Ctrl+N Keys (i.e., by pressing the N Key while holding down the
Ctrl Key).
If the menu is displayed, New can also be selected by pressing the N Key (i.e.,
the underlined letter).
NC Unit data, such as parameters, sequences, and speeds, can be moved to
other NC Units in the same project in units of NC Units either using drag-and-
drop or by using the Cut and Paste commands. Data can also be copied
using the Copy and Paste commands.
NC Unit data can be moved between CPU Units of the same series. The fol-
lowing example shows how to move the data for NC2 on PC1 to PC2.
Either of the following 2 methods can be used.
Section 2-3