Introduction; What Is Cx-Position; Applicable Nc Units; Features - Omron SYSMAC W398-E1-1 Operation Manual

Introduction

1-1

Introduction

1-1-1

What Is CX-Position?

1-1-2

Applicable NC Units

1-1-3

Features

Data Management and
Editing in Project Units
2
The CX-Position is a software package that enables the setting, transfer, stor-
age, and printing of data used with Position Control Units (referred to as NC
Units in this manual), as well as monitoring of NC Unit operating status.
The CX-Position runs on a Windows 95, 98, 2000, or NT operating system.
NC Unit
CX-Position can be used with the following NC Units.
NC Unit model number
CS1W-NC113/133/213/233/413/433
CS1W-NC113/133/213/233/413/433
Note For details on the system configuration, refer to 1-2 System Configuration.
The CX-Position enables data for several NC Units (96 NC Units max. per PC)
on several PCs (1,000 max.) to be handled as 1 project. Data is displayed in
tree format with parameter data, sequence data, speed data, acceleration/
deceleration data, dwell times, and zone data displayed under the corre-
sponding NC Unit, NC Units displayed under the corresponding PC, and PCs
displayed under the corresponding project.
Data (e.g., parameter
data, position data) used
with the NC Unit is set and
transferred.
The NC Unit's operating
status (e.g., present
position, I/O status, and
error display) is monitored.
Section 1-1
Computer with
Windows
operating system
PC series
CS Series
CJ Series