Adding And Deleting Nc Units; Adding An Nc Unit; Deleting An Nc Unit - Omron SYSMAC W398-E1-1 Operation Manual

Adding and Deleting NC Units

3-3

Adding and Deleting NC Units

3-3-1

Adding an NC Unit

1,2,3...
3-3-2

Deleting an NC Unit

1,2,3...
Use the following procedure to add an NC Unit to a PC.
1. Select the PC to be added to from the project tree.
2. Either select Edit/New NC (M), or right-click and select New NC (M) from
the pop-up menu.
3. Enter the NC Name. New NC @ (where @ = 1, 2 etc.) is the default name.
4. Set the NC Type by clicking on the NC Type drop-down list and selecting.
5. Select the Unit No. allocated to the NC Unit (as a Special I/O Unit)
6. Enter a comment if required.
7. Click the OK Button to add the NC Unit to the project.
1. Select the NC Unit to be deleted from the project tree, and select Edit/Re-
move DEL, press the DEL Key, or right-click and select Remove/DEL from
the pop-up menu.
2. A dialog box will be displayed asking "Do you want to delete?" Click the OK
Button.
Section 3-3
41