Omron SYSMAC W398-E1-1 Operation Manual page 22

Basic Operating Procedure
Install CX-Position.
Install FinsGateway.
Connect to the CPU Unit's
built-in RS-232C port.
Start CX-Position.
Create a new project.
Add PCs to the project
Add NC Units to the PCs in the project.
Create/edit NC Unit data.
Save the project.
Initialize the NC Units and CPU Unit.
Make communications settings for
FinsGateway and start up communications.
Download data to the NC Units.
Write data to the flash memory in NC Units.
Perform positioning with the NC Units.
Monitor the NC Units.
8
Refer to 2-1 Installation.
Refer to 2-1 Installation.
Refer to 2-2 Connecting to a PC.
Refer to 2-3 Basic Operations.
Refer to 3-1 Creating New Projects.
Refer to 3-2 Refer to 3-2
Adding and Adding and
Deleting PCs. Deleting PCs.
Refer to 3-3
Adding and
Deleting NC Units. The Network Address and Node
Address in Network Type must be
set to the settings used in
FinsGateway.
Refer to
Network Address:
SECTION 4
Set the same setting as in Network
Editing Settings.
Number under Network in
FinsGateway. (Default setting for
Host Link connection: 0.)
Refer to
Node Address:
SECTION 5
Set the same setting as in Node
Saving and
under Nodes in FinsGateway.
Reading Projects.
(Default setting for Host Link
connection: 240.)
Refer to 6-1
Default
Configurations for
Connecting Online.
Refer to 6-2
FinsGateway
Configuration
and Startup.
Refer to 7-1 Downloading Data.
Refer to 7-4 Writing Data to Flash Memory.
Refer to the Operation Manual for the NC Unit.
Refer to SECTION 8 Monitoring NCs.
Section 1-5