FPI CI2700 Manual page 189

CI2600/ HI400
7. Reinstall unit door (removed in Step 1), attach the left and right side
rails to the back of the bottom fascia panel using four 7/16'' bolts, slide
each rail upward before tightening. (Rails may need to be bent slightly
outward to get a good fit).
Rail system secured w/bolts
8. Apply the flat self adhesive gasket (not shown) to the face of the unit just
above the fan opening. Install the seal/cushion to line up with the top of
the slide out door. With the door in closed position,take the bottom fascia
and line up the wheels and rails with the rails on the unit. When lined up,
lift up and into the rail system and slide into position.
9. Apply self adhesive gasket to protect enamel surfaces from chipping.
Take the top fascia panel and gently slide the bypass rod through the
hole in the fascia panel, use caution to avoid chipping enamel. Lift the
fascia panel up slightly - push back to engage the brackets installed on
Step 1.
Self adhesive gasket
919-323b
Rail System
Back view of Top Fascia Panel lining up with the
brackets installed in Step 1
10. Re-install bypass knob and door.
Completed Optional Hampton Cast Faceplate
Note: If installing optional cast grill - follow installation instructions in this
manual.
2
installation
CI2700/HI500 Wood Insert |
23
|
23
06/16/20