Low Profile Faceplate Installation - FPI CI2700 Manual

installation
|
20

LOW PROFILE FACEPLATE INSTALLATION

LOW PROFILE FACEPLATE INSTALLATION
Remove unit door prior to installation of faceplate.
Remove all contents from the package and lay out.
NOTE: Bolts may be pre-installed on unit and will need to be removed
prior to each step of the noted instructions. As a result, there may be
spare bolts.
1. Install tool and handle holder to the left side of the unit with an 7/16"
bolt as shown below. (Note: part is packed with the manual package).
Handle / Tool holder
2. Install the upper left and right brackets using the four 7/16" bolts.
Identify proper orientation below before installing.
Brackets with Bolts
Left Bracket
3. Remove the bypass knob on the bypass rod by turning counter clock-
wise - pull bypass rod forward to the open position.
Remove bypass knob from
919-322a
20 | CI2700/HI500 Wood Insert
Right Bracket
the bypass rod
NOTE: If installing blower, optional Fan cassette must be installed prior at
this point. See fan installation instructions for details.
If not installing blower—proceed to Step 6.
4. Remove dummy plate from left side of faceplate by removing 2 screws.
Set screws aside, use to secure the fan switch assembly in Step 5.
Dummy Plate
5. With fan cassette in position—take the fan switch assembly (attached
to the fan cassette wiring harness) and install into opening created by
dummy plate removal. Ensure fan switch assembly is fully seated onto
faceplate and secure with 2 screws from Step 4.
Install fan switch assembly
1
CI2600
06/16/20