S.bus Servo Link - FUTABA 6K Instruction Manual

S.BUS servo link

S.BUS
Function
An S.BUS(2) servo can memorize the channel
and various settings you input. Servo setting can
be performed on the T6K screen by wiring the
servo as shown in the figure.
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
（1 second）
S.BUS Servo setting
⑤ "READ" is chosen by Jog key, Press
the Jog key for 1 second.
* With some S.BUS(2) servos, there are some functions with
cannot be used. If a function cannot be used, the display
screen will change. (Only the function which can be used by
a servo is displayed.)
* After reading completion, with connection of the above figure,
if a stick is moved, the test of operation of the servo can be
operated and carried out.
"S.BUS"
② Select
from the menu with the Jog
key.
④ Connect a S.BUS servo to
set up.
T6K
⑥ READ is completed and
the item in which data of
S.BUS servo and a setup
are possible is displayed.
* "COMU-ERROR" :
It is failure of READ. Check a
servo and connection.
Next page S.BUS servo function
(Common)
③ Open the setting screen by
pressing the Jog key.
Receiver battery
HUB
S.BUS/
S.BUS2 Servo
⑦ S.BUS servo is set up.
⑧ "WRITE" is chosen and Jog key
is pressed for 1 second.
The writing is done when "Complete"
is shown.
87