S.bus Servo - FUTABA 32MZ Instruction Manual

S.BUS Servo

An S.BUS servo can memorize the channel and various
settings itself. Servo setting can be performed on the
T32MZ screen by wiring the servo as shown in the igure.
●Servo ID number
Individual ID numbers are memorized for your S.BUS
servos in your T32MZ. When a servo is used (as shown
at the right), the servo ID number is automatically read by
the transmitter.
If you use multiple S.BUS servos and do not want to
change the settings on all that are mounted in a fuselage,
only the desired servo in the group can be set by entering
the ID of that speciic servo.
* S9070SB cannot be arranged by T32MZ.
* With S.BUS servos of use, there are a function which can
be used, and an impossible function and a display screen
changes.
(Only the function which can be used by a servo is displayed.)
● Call the following setting screen by pressing the
[S.BUS Servo] button in the System Menu.
Procedure for changing S.BUS servo setting
1. Select [S.BUS Servo] of the System Menu.
2. Wire the servo as shown in the igure above.
3. Press [Recall]. The ID and current setting of that
servo are displayed.
4. When multiple servos are connected change [INH]
at the right side of the ID number on the screen to
[ACT] and enter the ID of the servo you want to set.
5. Set each item. (Please see the next page.)
6. Press [Write]. The settings are changed.
WARNING
While S.BUS servo writes, you aren't supposed
to remove a connection of a servo and turn off
a power supply of a transmitter.
*Data of S.BUS servo is damaged and breaks down.
S.BUS servo setting
●Return to System Menu
ID
Input "42" to the right
screen by the button from
which appeared. (First's 0
isn't input.)
ID
Input "87" by the ID input
keyboard which appeared.
(First's 00 isn't input.)
ID
* After reading completion, with connection of the above
igure, if a stick is moved, the test of operation of the servo
can be operated and carried out.
Servo ID input example
ACT
0 0
Press
ACT
42 0
Press
ACT
42 87
＜ System Menu ＞
S.BUS servo
69