Table of Contents
Advertisement
Using V-TAIL ( ACRO ):
NOTE: If V-TAIL is active, you cannot activate ELEVON or AILEVATOR functions. If one of these functions is active, an error
message will be displayed and you must deactivate the last function prior to activating V-TAIL .
NOTE: Be sure to move the elevator and rudder sticks regularly while checking the servo motions. If a large value of
travel until no binding occurs.
Adjustability:
• Independently adjustable travels allow for differences in servo travels.
• Rudder differential is not available. (To create rudder differential, set RUD1 and 2 to 0 . Next, use two programmable
mixes, RUD-ELE and RUD-RUD , setting different percentages for up and down. These are your new rudder travels. Trim off
and switch assignment null so you can't accidentally turn off rudder. See PROG.MIX , p. 65.)
GOAL of EXAMPLE:
Activate V-TAIL .
Adjust left elevator servo to 95% travel
Where next?
V-TAIL
functions are combined for the two tail surfaces. Both elevator and rudder travel
can be adjusted independently on each surface.
STEPS:
Open the V-TAIL function.
Activate the function.
optional: adjust the travels separately
left to 95%
Close menu.
Adjust END POINTs : see p. 36 and SUB-TRIMs : see p. 46.
Set up dual/triple rates and exponential( D/R , EXP ): see p. 39.
Set up ELE-FLAP mix: see p. 59.
INPUTS:
for 1 second.
to V-TAIL .
to MIX .
to ELE1 .
Repeat as necessary for other servos.
55
to ACT .
to 95% .
Advertisement
Table of Contents
