Snap Roll (Air Only) - FUTABA 8FG SUPER Instruction Manual

SNAP ROLL
This function selects the switch and rate
adjustment of ailerons, elevators, and rudder when
a snap roll is performed.
● Four snap roll directions can be set. (Right/up,
right/down, left/up, left/down)
● Operation mode: When [Master] mode is selected,
the Snap Roll function is turned ON/OFF by the
master switch. It is possible to set the direction
switch was switched to the direction in which you
want to snap roll. When [Single] mode is selected,
the snap roll in each direction can be executed
by means of independent switches and positions.
● A safety switch can be set to prevent the
inadvertent activation of the snap roll. For
example, the landing gear is lowered, even if
the switch is turned on accidentally the snap roll
would not be executed. The snap roll switch is
activated only when the safety switch is OFF.
● Select [SNAP ROLL] at the Model menu
and access the setup screen shown
below by touching the RTN button.
● Select the function name
and return to the Model
menu by touching the
RTN button.
118 <Model Menu (Airplane/Glider Functions)>
[Corresponding model type]: Airplane, general
● Mode: [Master]
● Safety SW: [SG] (Safety measure)
● Master SW: [SH] (Main switch for executing
● Direction switches:
*The snap roll up side left and right and down side left and right
Right/Up: OFF [SD]
Right/Down: OFF [SD]
Left/Up: OFF [SA]
Left/Down: OFF [SA]
(Example) Setting example for F3A
snap roll)
direction switches are selected here.
<SensorTouch™>
● To next page
● Master/single mode
selection
● Direction switches
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value