TM_s-MEXT_ME28relC_00_12_19_EN
The access to the "User", "Service" and "Factory" menus requires a password. The following chapter explains how to manage the passwords.
2.2.2
Password management
There are three menu levels that may be accessed upon entering a numeric password. The access levels are as follows:
•
"User" password, for the user.
•
"Service" password, for maintenance and assistance operators;
•
"Factory" password, for the sole and exclusive use of the manufacturer's employees (not to be disclosed externally).
To enter the password, type every single digit in the set order from left to right.
To move from one digit to the next, just press the [ENTER] key.
To move from one digit to the previous, just press the [ESC] key. If the cursor should be on the first digit to the left, then this brings back to the main window.
The following table shows the values of the "User" password, the "Service" password and the "Factory" password:
The "Factory" password is managed using the Service software, which for each controller configures a Factory password, which is then saved in the job and is only
available to after-sales service.
Once at the last digit of the password, by pressing the [ENTER] key the software will compare the entered password with those stored in its memory. If the entered password
should not be correct, the message "Wrong Password !!!" will appear for a few instants, all digits will be reset, and the cursor will move back to the first digit, on the left end of
the password space.
To go back with the cursor to the previous password digit, just press the [ESC] key.
By pressing the [ESC] key with the cursor on the first digit on the left, the system goes back by one level.
Technical manual
Esc
Esc
Esc
Esc
Esc
Esc
Esc
Esc
Figure 2-5: Tree for moving around the "Factory" menu
USER PASSWORD
1234
(modifiable)
SERVICE PASSWORD
9990
(modifiable)
Factory menu
Selection Config.
Esc /
menu
Selection
Esc /
Functions menu
Selection
Esc /
Compressor menu
Selection Valve
Esc /
menu
Selection Safety
Esc /
menu
Selection Safety 2
Esc /
menu
Selection Default
Esc /
menu
Selection
Esc /
Super User menu
FACTORY PASSWORD
0000009982
(modifiable)
11
Config. menu
Functions menu
Compressor menu
Valve menu
Safety menu
Safety 2 menu
Default menu
Super User menu
TRANSLATION OF THE ORIGINAL INSTRUCTIONS