Mitsubishi Electric s-MEXT-G00 006 Technical Manual page 35

TM_s-MEXT_ME28relC_00_12_19_EN
Mask of the terminal
--------------- P24.20
Aux address 129 temp.
probe adjust: 0.0 °C
--------------- P24.21
Aux address 129 humid.
probe adjust: 00.0 %
--------------- P24.23
Temp. updating diff.
probe ind.128: 0.5°C
--------------- P24.24
Humid. updating diff.
probe ind.128: 0.5 %
--------------- P24.25
Temp. updating diff.
probe ind.129: 0.5°C
--------------- P24.26
Humid. updating diff.
probe ind.129: 0.5 %
Demand
Limit

Demand Limit
NOT Available
Lan

Available ONLY for the
MASTER unit (Addr.:1)
--------------- P26.01
Unit number in LAN:
2
--------------- P26.02
Average calcul. in LAN
status:
--------------- P26.03
Stand-by mode in LAN
status:
--------------- P26.04
Stand-by cycle time
in LAN: 168h
Technical manual
Description
Parameter for calibrating the auxiliary temperature / humidity probe
Only visible when the probe is present
Parameter for setting the room temperature / humidity sensor resolution
Parameter for setting the auxiliary temperature / humidity sensor resolution
Access mask to Demand Limit submenu. Press "Up" or "Down" to scroll the other masks and "Esc" to return to
the submenu.

Mask displayed to warn that the Demand Limit function cannot be enabled.
Access mask to Lan submenu. Press "Up" or "Down" to scroll the other masks and "Esc" to return to the
submenu.

This mask indicates that the LAN menu is only available for the Master unit.
This mask is displayed only at the Slave units (pLAN address=2÷10).
Parameter for configuring the number of units in LAN (2 to 16) and for
configuring the average calculation in LAN function (N:disabled - Y:enabled)
N
Parameter for configuring the standby mode in LAN function (N:disabled - Y:enabled) and parameter for setting
the standby cycle time in LAN
N
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
35
N. Par.
24.20
24.21
24.23
24.24
24.25
24.26
26.01
26.02
26.03
26.04