Mitsubishi Electric s-MEXT-G00 006 Technical Manual page 33

TM_s-MEXT_ME28relC_00_12_19_EN
Mask of the terminal
Fan

--------------- P23.01
Fan nominal
speed: 070%
--------------- P23.02
Economy mode fan
status:
--------------- P23.03
Fan speed in
economy mode: 50%
--------------- P23.07
Air Flow modulation
with inverter mod.
status:
--------------- P23.08
MIN fan speed when
modul. active: 050%
--------------- P23.10
Fan speed when active
dehumidif.: 060%
--------------- P23.11
Air pressure diff.
scan time: 060s
--------------- P23.61
Post-ventilation
for el.heater status:Y
--------------- P23.62
Post-ventilation time
for el.heater: 060s
--------------- P23.65
Const. flow rate set:
02500 m3/h
Technical manual
Description
Access mask to fan submenu. Press "Up" or "Down" to scroll the other masks and "Esc" to return to the submenu.

Parameter for setting the nominal speed of the internal fan
Parameter for configuring the internal fan Economy Mode function (N:disabled - Y:enabled)
Parameter for setting the internal fan speed with the Economy Mode function enabled
N
Parameter for configuring the Internal fan modulation function for inverter compressor units (N:disabled -
Y:enabled)
Only visible with constant flow rate check and constant DeltaP disabled
Y
Parameter for setting the minimum speed of the internal fan in modulation for inverter compressor units
(maximum reduction of design speed)
Parameter for setting the fixed internal fan speed for units with inverter compressor in dehumidification
Parameter for setting the differential air pressure scan time and
parameter for configuring the EC condensation control function (N:disabled - Y:enabled)
Parameters for configuring the post-ventilation function for the heaters and the post-ventilation time.
Visible when the electric heaters are present
Parameter used to set the Constant flow rate control setpoint (divided by 100)
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
33
N. Par.
23.01
23.02
23.03
23.07
23.08
23.10
23.11
23.61
23.62
23.65