Address Setting The Control Board - From The User Terminal; User Terminal Address Setting; Network Status Display (Netstat) - Mitsubishi Electric s-MEXT-G00 006 Technical Manual

TM_s-MEXT_ME28relC_00_12_19_EN
20.2.5

Address setting the control board - from the user terminal

1) Press and hold [UP]+[DOWN]+[ENTER] at the same time for at least 3 seconds to enter configuration mode. A mask is
displayed with the cursor flashing in the top left corner.
2) Press [ENTER] once to modify the address of the terminal (display address setting). The cursor will move on the address
field.
Press [UP] or [DOWN] to select the value 0 and then press [ENTER] again to confirm. The value will be saved in the
permanent memory of the terminal.
3) The appearance of the next mask indicates that the keyboard address has been set.
4) Turn the board off and then on again by pressing and holding [ALARM]+[UP] at the same time. Wait until the board
address setting mask appears, then release the keys.
The mask appears for setting the required address.
ATTENTION
This is a time procedure; hence if the parameters are not set in a few seconds, the display turns off. In such case, repeat the process.
20.2.6

User terminal address setting

Once the keyboard has been connected to the device, run the following procedure.
1) Press and hold [UP]+[DOWN]+[ENTER] at the same time for at least 3 seconds to enter configuration mode. A mask is
displayed with the cursor flashing in the top left corner.
2) Press [ENTER] once to modify the address of the terminal (display address setting). The cursor will move on the address
field.
Press [UP] or [DOWN] to select the required value of the address and then press [ENTER] again to confirm. The value will be
saved in the permanent memory of the terminal.
3) The appearance of the next mask indicates that the keyboard address has been set.
4) If an empty mask or a mask showing "NO LINK" appears after pressing [ESC], it means that the keyboard is not
communicating with any boards. It is necessary to set the address of the board or configure the local network (LAN).
ATTENTION
This is a time procedure; hence if the parameters are not set in a few seconds, the display turns off. In such case, repeat the process.
20.2.7

Network status display (NetSTAT)

Press and hold the [UP]+[DOWN]+[ENTER] configuration buttons for at least 10 seconds (only in the LAN mode) to open the synoptic screen of the network seen from the
user terminal in question. The screen exemplifies the status of the LAN, showing how many and what devices are connected, and with which address.
To exit the NetSTAT procedure, press [ENTER].
Technical manual
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
109
Display address
Setting..........: 21
I/O Board address: 01
Display address
Setting..........: 00
I/O Board address: --
Display address
Changed
#################
selftest
pleasewait...
#################
Display address
Setting..........: 00
I/O Board address: --
Display address
Setting..........: 21
I/O Board address: --
Display address
Changed
NO LINK