Password Management - Mitsubishi Electric s-MEXT-G00 006-044 Operation Manual

Computer room air conditioner

Table of Contents

UM_s-MEXT_ME28relC_00_12_19_ML

The access to the "User", "Service" and "Factory" menus requires a password. The following chapter explains how to manage the passwords.

2.2.2.

Password management

There are three levels that may be accessed upon entering a numeric password.

To enter the password, type every single digit in the set order from left to right.

To move from one digit to the next, just press the [ENTER]

To move from one digit to the previous, just press the [ESC]

window.

The following table shows the value of the default user password:

Once at the last digit of the password, by pressing the [ENTER] key the software will compare the entered password with those stored in its memory. If the

entered password should not be correct, the message "Wrong Password !!!" will appear for a few instants, all digits will be reset, and the cursor will move

back to the first digit, on the left end of the password space.

To go back with the cursor to the previous password digit, just press the [ESC] key.

By pressing the [ESC] key with the cursor on the first digit on the left, the system goes back by one level.

To change the "User" password access the "Info" menu inside the "User" menu and scroll the masks until the "User" password change mask appears:

USER MANUAL

G.2

Esc

Figure 2-3: Tree for moving around the "User menu"

key.

key. If the cursor should be on the first digit to the left, then this brings back to the main

USER PASSWORD

1234