Advanced Routing - TP-Link TL-WR802N User Manual

Chapter 4
6. Select
7. Select
through the Router
Done!
Now only the specific host(s) can visit the target(s) within the scheduled time period.
Note:
When LAN Host
UDP, ICMP. The default setting is

4. 11. Advanced Routing

Static Routing is a form of routing that is configured manually by a network administrator
or a user by adding entries into a routing table. The manually-configured routing
information guides the router in forwarding data packets to the specific destination.
4. 11. 1. Static Route List
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to
• To add static routing entries:
1. Click
2. Enter the following
Downloaded from ManualsNet.com
Enable Internet Access Control
Allow the packets specified by any enabled access control policy to pass
as the default filter policy and click Save.
and Target are both set to be the MAC Address mode, you need to set Protocol: ALL, TCP,
ALL and it is recommended to keep the default setting.
Advanced Routing > Static Route
Add New.
information.
search engine
Configure the Router in Wireless Router Mode
to enable Access Control function.
List.
44