TP-Link TL-WR802N User Manual page 113

Chapter 5
•
•
•
•
•
•
•
Tunnel 6to4
•
5. 15. 3. IPv6 LAN
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to
Downloaded from ManualsNet.com
PPP Username/Password
your ISP. These fields are case-sensitive.
Authentication Type – Choose one authentication type from AUTO-AUTH, PAP,
CHAP and MS-CHAP.
Addressing Type - There are two types of assignation for IPv6 address:
SLAAC (Stateless address auto-configuration) and DHCPv6 (Dynamic Host
Configuration Protocol for IPv6) Server.
MTU(Bytes) - The normal MTU (Maximum Transmission Unit) value for most
Ethernet networks is 1500 Bytes. For some ISPs, you may need to modify the
MTU. But this is rarely required, and should not be done unless you are sure it is
necessary for your ISP connection.
Enable MLD Proxy - Enable the Multicast Listener Discovery (MLD) Proxy
function if you need.
Use IPv6 address specified by ISP
Set IPv6 DNS Server manually
and secondary IPv6 DNS server.
WAN Connection - Display the available wan connection.
IPv6 > IPv6 LAN and configure the IPv6 LAN settings as needed.
search engine
Configure the Router in WISP Mode (Hotspot Mode)
- Enter the User Name and Password provided by
- Input a static IPv6 address from the ISP.
- Enter the IP address of the IPv6 DNS server
109